»local

Kind: Enhanced

The local backend stores state on the local filesystem, locks that state using system APIs, and performs operations locally.

»Example Configuration

terraform {
  backend "local" {
    path = "relative/path/to/terraform.tfstate"
  }
}

terraform {
  backend "local" {
    path = "relative/path/to/terraform.tfstate"
  }
}

»Data Source Configuration

data "terraform_remote_state" "foo" {
  backend = "local"

  config = {
    path = "${path.module}/../../terraform.tfstate"
  }
}

data "terraform_remote_state" "foo" {
  backend = "local"

  config = {
    path = "${path.module}/../../terraform.tfstate"
  }
}

»Configuration variables

The following configuration options are supported:

• path - (Optional) The path to the tfstate file. This defaults to "terraform.tfstate" relative to the root module by default.
• workspace_dir - (Optional) The path to non-default workspaces.

»Command Line Arguments

For configurations that include a backend "local" block or that default to the local backend by not specifying a backend at all, most commands that either read or write state snapshots from the backend accept the following additional arguments:

• -state=FILENAME - overrides the state filename when reading the prior state snapshot.

• -state-out=FILENAME - overrides the state filename when writing new state snapshots.

  If you use -state without also using -state-out then Terraform will use the -state filename for both -state and -state-out, which means Terraform will overwrite the input file if it creates a new state snapshot.

• -backup=FILENAME - overrides the default filename that the local backend would normally choose dynamically to create backup files when it writes new state.

  If you use -state without also using -backup then Terraform will use the -state filename as a filename prefix for generating a backup filename. You can use -backup=- (that is, set the filename to just the ASCII dash character) to disable the creation of backup files altogether.

These three options are preserved for backward-compatibility with earlier workflows that predated the introduction of built-in remote state, where users would write wrapper scripts that fetch prior state before running Terraform and then save the new state after Terraform exits, in which case the three arguments would typically all be paths within a temporary directory used just for one operation.

Because these old workflows predate the introduction of the possibility of multiple workspaces, setting them overrides Terraform's usual behavior of selecting a different state filename based on the selected workspace. If you use all three of these options then the selected workspace has no effect on which filenames Terraform will select for state files, and so you'll need to select different filenames yourself if you wish to keep workspace state files distinct from one another.

These three options have no effect for configurations that have a different backend type selected.

We do not recommend using these options in new systems, even if you are running Terraform in automation. Instead, select a different backend which supports remote state and configure it within your root module, which ensures that everyone working on your configuration will automatically retrieve and store state in the correct shared location without any special command line options.